![background image](http://html1.mh-extra.com/html/club-car/2007-xrt-800/2007-xrt-800_maintenance-service-manual_2626829475.webp)
MOTOR (MODEL EJ4-4001)
Motor
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
Page 27-3
27
5. Remove both rear wheels.
6. Remove the nut, cup washer, and bushing from the bottom side of the shock absorber. Compress the
shock absorber (pushing upwards) to move it out of the way
(Figure 27-3, Page 27-3)
.
7. Remove the nuts and bolts mounting the rear leaf springs to the shackles.
8. To gain easier access to the motor, lower the transaxle as low as it will go. If more room is needed,
remove the jack from beneath the transaxle and allow the springs to rest on the floor
(Figure 27-3,
Page 27-3)
.
9. Remove the four bolts that mount the motor to the transaxle
(Figure 27-24, Page 27-15). See following
CAUTION.
ý
CAUTION
• Do not position fingers under motor when sliding motor off of the input shaft in step 9.
Fingers may get pinched when motor disengages.
10. Carefully slide the motor away from the transaxle until the motor spline disengages the input shaft and
remove the motor from the vehicle.
Figure 27-1 Lift Vehicle with Floor Jack
Figure 27-2 Vehicle Supported on Jack Stands
Figure 27-3 Lower Axle
Summary of Contents for 2007 XRT 800
