![background image](http://html1.mh-extra.com/html/club-car/2007-xrt-800/2007-xrt-800_maintenance-service-manual_2626829137.webp)
TROUBLESHOOTING AND ELECTRICAL SYSTEM: 800 AND 810 GAS
Test Procedures
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
Page 11-13
11
TEST PROCEDURE 4 – KEY SWITCH (STARTER CIRCUIT)
See General Warning on page 1-1.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL posi-
tion. Chock the wheels.
2. Disconnect the battery cables as instructed.
See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2.
3. Remove the instrument panel.
See Key Switch Removal, Section 13, Page 13-14.
4. Ensure that the connector is connected correctly and is tight. If it is not, repair or replace as necessary.
5. Insert the key and turn the key to ON. Place the red (+) probe of the multimeter on the (B) terminal and
the black (–) probe on the (L) terminal of the key switch. The reading should be continuity. If the reading
is incorrect, replace the key switch
(Figure 11-9, Page 11-14)
.
See Key Switch Removal, Section 13,
Page 13-14.
6. With the key still in the ON position, place the red (+) probe of the multimeter on the (B) terminal and the
black (–) probe on the (S) terminal of the key switch. The reading should show no continuity. If the reading
is incorrect, replace the key switch.
See Key Switch Removal, Section 13, Page 13-14.
If the reading
is correct, leave the probes connected and proceed to the next step.
7. Insert the key and hold the key in the START position. The reading should be continuity. If the reading
is incorrect, replace the key switch
(Figure 11-10, Page 11-14)
. With the red (+) probe of the multimeter
on the (B) terminal and the black (–) probe on the (L) terminal of the key switch, the reading should be
continuity. If either reading is incorrect, replace the key switch.
See Key Switch Removal, Section 13,
Page 13-14.
Figure 11-8 Battery Ground Cable Test
Place black (–)
probe on
frame.
Disconnect the 6 gauge
black wire from the battery.
Place red (+) probe on
disconnected end of wire.
2m
20
m
200
m
2k
200
200
200
200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK
5XL
V
V
V
A
!
!
COM
200nA
MAX
1000 ---
750V
FUSED
Summary of Contents for 2007 XRT 800
