![background image](http://html1.mh-extra.com/html/club-car/2007-xrt-800/2007-xrt-800_maintenance-service-manual_2626829402.webp)
IQ DISPLAY MODULE (IQDM) AND IQDM-P DIAGNOSTICS
Introductory Display
Page 22-2
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
22
INTRODUCTORY DISPLAY
Immediately after the handset is connected to the vehicle, it begins loading the vehicle speed controller infor-
mation. After a few seconds, the screen displays the following menu items:
•
Program (IQDM-P only)
•
Monitor
•
Faults
•
Functions
•
Information
•
Programmer Setup
In the event that the handset does not display any information, or the screen is difficult to read, refer to the
IQDM troubleshooting procedures.
See IQDM and IQDM-P Handset Troubleshooting on page 22-16.
MENU NAVIGATION
The NAVIGATION BUTTON is the four-arrow button located on the left side of the handset
(Figure 22-3,
Page 22-3)
. This button is used to navigate through and select menus. Pressing the up or down arrows allows
the user to scroll through the menu items. When the box beside the desired menu is blinking, pressing the
right arrow selects that menu item. Pressing the left arrow allows the user to go back one screen.
The CHANGE VALUE BUTTON is the button located on the right side of the handset
(Figure 22-3,
Page 22-3)
. This button allows the user to change values by pr or –.
The three yellow buttons labeled 1, 2 and 3 are BOOKMARK BUTTONS
(Figure 22-3, Page 22-3)
. These
buttons allow the user to bookmark up to three specific screens for rapid return to those screens. To bookmark
a specific display screen, have the desired screen displayed and simply press and hold a bookmark button
until the statement “bookmark set” is displayed. When it is necessary to go back to the bookmarked screen,
rapidly press and release the appropriate bookmark button.
See following NOTE.
NOTE:
When going to a bookmarked display screen, be sure to rapidly press and release the button. If the
button is pressed and held for too long, the bookmark will be overridden with the current screen.
The following menus are accessible on the IQDM handset:
Program (IQDM-P only)
The
program
menu allows the user to view and change custom speed controller settings.
See Program Menu
on page 29-2.
Monitor
The
monitor
menu displays values for certain parameters to facilitate speed controller troubleshooting.
See
Monitor Menu on page 22-4.
Faults
The
faults
menu displays all faults recorded by the speed controller since the history was last cleared. Each
fault is listed only once under the history menu, even if the fault has occurred multiple times.
See Faults Menu
on page 22-6.
Each fault is listed at the bottom of the monitor menu. The right hand column lists the number
of occurrances for each fault. The number of occurrances is reset to zero each time the fault history is cleared.
Summary of Contents for 2007 XRT 800
