Club Car 2007 XRT 800, Maintenance Service Manual

Page: 408 / 516

IQ DISPLAY MODULE (IQDM) AND IQDM-P DIAGNOSTICS Menu Navigation
Page 22-8 2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
22
Fault Recovery
When a fault is detected by the speed controller, the speed controller will attempt to recover from the fault and
resume normal operation. In the case of an intermittent problem such as a loose wiring connection, the con-
troller
may be able to recover and operate normally for a while, but the problem should be repaired before
placing the vehicle in service.
Depending on the type of fault, the controller will attempt to recover immediately after the condition clears or
after the accelerator pedal has been cycled (released and pressed again).
The following faults can be detected by the IQ System controller:
HW Failsafe
The armature drive FET’s (field effect transistors) regulate the armature current. If the speed controller
detects a failure of the armature drive FET’s or circuitry, a
hardware failsafe fault is detected.
CONTROLLER
FAULT CONTROLLER ATTEMPTS
TO RECOVER
HW FAILSAFE When key switch is cycled
THROTTLE FAULT 1 When condition clears
SPEED SENSOR When condition clears
MAIN WELDED When condition clears
MAIN DRIVER ON When condition clears
MAIN DRIVER OFF When accel. pedal is cycled
MAIN CONT DNC When accel. pedal is cycled
MAIN COIL FAULT When accel. pedal is cycled
FIELD MISSING When accel. pedal is cycled
HPD When accel. pedal is cycled
PROC/WIRING When condition clears
OVERVOLTAGE When condition clears
UNDERVOLTAGE When condition clears
THERMAL CUTBACK When condition clears
MOTOR STALL When condition clears
MAIN DROPOUT When accel. pedal is cycled
OPEN ARMATURE
When condition clears and
accel. pedal is cycled
MAX PASSWORD TRIES
When Tow/Run switch is
cycled
INCORRECT PASSWORD
When Tow/Run switch is
cycled
HIGH SPEED WALKAWAY
When Tow/Run switch is
cycled
KEY SWITCH SRO When Key Switch is cycled