Club Car 2007 XRT 800, Maintenance Service Manual

Page: 64 / 516

ACCELERATOR AND BRAKE PEDAL GROUP Pedal Group Adjustment – Gasoline Vehicle
Page 5-14 2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
5
5. Adjust accelerator pedal height.
5.1. Loosen the nut and bolt (Figure 5-17, Page 5-14) securing the accelerator pedal to the pivot plate.
5.2. Clamp the accelerator pedal adjustment tool (CCI P/N 101871001) to the accelerator pedal, with
the end marked accelerator pedal height closest to the floorboard (Figure 5-18, Page 5-14) . Press
the accelerator pedal until the end of the tool rests against the floorboard; (pedal height should be
5-5/8 inches (14.3 cm). Use a rubber strap to hold pedal in position against the floorboard and then
tighten nut to 26 ft-lb (35.3 N·m).
6. Adjust the accelerator rod. See following DANGER.
ý
DANGER
• Before servicing, turn the key switch to OFF and place the Forward/Reverse handle in the
NEUTRAL position.
• To prevent accidentally starting the vehicle, disconnect the battery as instructed in WARNING
“To avoid unintentionally starting...” in General Warning on page 1-2. This will prevent the
possibility of the vehicle running over you when you are adjusting the accelerator rod.
6.1. Remove the electrical box screw and cover. See preceding DANGER.
Figure 5-16 Brake Rod Adjustment Figure 5-17 Accelerator Pedal Height Adjustment
Figure 5-18 Accelerator Pedal Height Adjustment
ST
OP
PARK
GO
ACCELERATOR PEDAL
ADJUSTMENT TOOL
(CCI P/N 101871001)
RUBBER STRAP
GO
ST
OP
PARK
MICRO BR
EAK POINT
MICRO BRE
AK POINT