![background image](http://html1.mh-extra.com/html/club-car/2007-xrt-800/2007-xrt-800_maintenance-service-manual_2626829308.webp)
UNITIZED TRANSAXLE: 800/810 GASOLINE VEHICLES
Axle Shaft
Page 18-4
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
18
ý
CAUTION
• Do not tighten the bearing puller wedge attachment against the axle shaft. This could damage
the axle shaft when pressing the bearing and collar off.
2. Press the bearing (71) and collar (73) off together
(Figure 18-6, Page 18-4).
See also
Figure 18-7,
Page 18-6
.
See following NOTE.
NOTE:
It may be necessary to heat the collar to remove it.
Do not remove the large axle retaining ring (70) from the axle
(Figure 18-6, Page 18-4)
. Since the
inner diameter of the retaining ring (70) is smaller than the outer diameter of the bearing (71), the
ring must be in place on the axle before a new bearing and collar are pressed on.
Figure 18-6 Differential Gear Case/Axle Tubes
74
73
70
71
74
73
70
68
76
75
67
70
71
73
74
72
71
72
Summary of Contents for 2007 XRT 800
