UNITIZED TRANSAXLE: 800/810 GASOLINE VEHICLES
Forward/Reverse Shifter Cable
Page 18-20
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
18
5. Install the ball joint socket (2) on the Forward/Reverse shifter assembly ball stud (3)
(Figure 18-54,
Page 18-21)
.
6. Attach Forward/Reverse cable at cable retainer (7).
7. Install wire tie (8) to secure wire harness to cable at the support bracket near the Forward/Reverse shifter
assembly.
See following WARNING.
ý
WARNING
• If wires are removed or replaced, make sure wiring and wiring harness is properly routed and
secured. Failure to properly route and secure wiring could result in vehicle malfunction,
property damage, personal injury, or death.
FORWARD/REVERSE SHIFTER CABLE ADJUSTMENT
With the shifter lever of the unitized transaxle in the NEUTRAL position
(Figure 18-54, Page 18-21)
, the For-
ward/Reverse handle (9) should be straight up. For minor adjustments, the nut (1) may be loosened and the
ball joint socket (2) rotated to get the proper adjustment
(Figure 18-54, Page 18-21). See following CAU-
TION.
ý
CAUTION
• Be sure threads of cable are engaged in ball joint socket at least 1/4 inch (6.35 mm). If ball
joint socket comes loose from the cable, the Forward/Reverse shifter will not operate
properly.
Figure 18-53 Forward/Reverse Cable Routing
ClubC
ar
ClubC
ar
Summary of Contents for 2007 XRT 800
