UNITIZED TRANSAXLE: 850 GASOLINE VEHICLE
Unitized Transaxle Removal
Page 19-12
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
19
15. Place blocks under the engine pan so they will completely support the engine and keep it
level to the
floor
(Figure 19-28, Page 19-12)
.
See following NOTE.
NOTE:
Place the blocks so they will support the engine when the transaxle is detached and moved away
from the engine.
16. Remove the drive belt.
16.1. Grasp belt midway between drive and driven clutch and pull up on belt to force the driven clutch
sheaves apart. Roll the belt counterclockwise while pulling it off driven clutch
(Figure 19-29,
Page 19-12)
.
17. Remove the driven clutch retaining bolt and remove the driven clutch from the unitized transaxle
(Figure 19-30, Page 19-12)
.
18. Loosen, but do not remove, the governor arm retaining bolt (1)
(Figure 19-31, Page 19-12)
. Remove the
governor arm from the shaft. Do not disconnect cables.
Figure 19-28 Position Powertrain on Wood Blocks
Figure 19-29 Remove Drive Belt
Figure 19-30 Driven Clutch
Figure 19-31 Governor Arm
6 in. (15.24 cm)
1
Summary of Contents for 2007 XRT 800
