![background image](http://html1.mh-extra.com/html/club-car/2007-xrt-800/2007-xrt-800_maintenance-service-manual_2626829340.webp)
UNITIZED TRANSAXLE: 850 GASOLINE VEHICLE
Unitized Transaxle Installation
Page 19-14
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
19
UNITIZED TRANSAXLE INSTALLATION
See General Warning on page 1-1.
1. Install the wheels.
See Wheel Installation, Section 8, Page 8-1.
2. Install the leaf springs.
See Leaf Spring Installation – All Vehicles, Section 9, Page 9-4.
3. Position the transaxle mounting plate on the two mounting studs at the rear of the engine, and then install
the two mounting nuts finger tight
(Figure 19-35, Page 19-14)
.
4. Install the remaining four mounting bolts and four nuts (one bolt and nut at each corner of the mounting
plate) finger tight.
5. Tighten the four corner nuts (with bolts) to 30 ft-lb (40.7 N·m). Tighten the two center nuts (on the engine
block studs) to 17 ft-lb (23.1 N·m)
(Figure 19-35, Page 19-14)
.
6. Install the accelerator cable bracket on transaxle case. Tighten the mounting screws to 134 in-lb (15.1
N·m)
(Figure 19-33, Page 19-13)
.
7. Install the governor cable bracket on transaxle case. Tighten the mounting screws to 134 in-lb (15.1 N·m)
(Figure 19-32, Page 19-13)
.
8. Install governor lever arm on governor shaft
(Figure 19-36, Page 19-14)
.
8.1. With the governor lever arm loose on the governor shaft, turn the governor arm shaft counterclock-
wise until it stops. Then pull the governor lever arm rearward until the carburetor throttle is in the
“wide open throttle” (WOT) position
(Figure 19-36, Page 19-14)
.
8.2. While holding the arm and shaft in the fully counterclockwise position, tighten the governor arm
lever nut to 35 in-lb (4.0 N·m)
(Figure 19-36, Page 19-14)
.
9. Install the key onto the input shaft
(Figure 19-37, Page 19-15)
.
10. Position the driven clutch on the transaxle input shaft and install the washer (yellow side facing out) and
mounting bolt. Tighten the mounting bolt to 14 ft-lb (19.0 N·m)
(Figure 19-37, Page 19-15)
.
11. Install the drive belt.
See Drive Belt Installation, Section 20, Page 20-3.
Figure 19-35 Transaxle Mounting
Figure 19-36 Governor Arm
Summary of Contents for 2007 XRT 800
