Yamaha WR250F(S), Owner'S Service Manual

Page: 178 / 864

SPEC
2 - 99
CABLE ROUTING DIAGRAM
Ê
Fasten the diode, rectifier/regulator lead and AC magneto cou-
pler (connected to the CDI unit), with the diode at its white tape
and the rectifier/regulator lead at its protecting tube.
Ë
Fasten the wire harness, starter motor lead and negative bat-
tery lead so that the plastic locking tie ends do not contact the
ignition coil lead.
Ì
Fasten the wire harness, rectifier/regulator lead, coolant reser-
voir hose, hot starter cable, negative battery lead and starter
motor lead.
Í
Fasten the wire harness, negative battery lead, starter motor
lead, rectifier/regulator lead and coolant reservoir hose at the
white tape for the negative battery lead.
Î
Fasten the wire harness at its white tape.
Ï
Fasten the wire harness, throttle position sensor lead (in the
wire harness), starter motor lead and negative battery lead.
Ð
Make sure that the throttle position sensor coupler does not go
outside the chassis.
Ñ
Fasten the throttle position sensor lead.
Ò
Pass the carburetor breather hoses, carburetor overflow hose
and coolant reservoir breather hose between the connecting
rod and cross tube (frame).
Ó
Fasten the neutral switch lead and oil hose together with the
plastic locking ties and cut off the tie ends.
Ô
Pass the cylinder head breather hose through the hose guides.
Õ
Fasten the neutral switch lead.
A
A
B-B
B
B
Þ
3
4
3
5
6
3
3 3
3
7
J
J
K
L
8
9
3
0
A
3
0
3
B
C
D
E
F
G
H
F
9
8
I
0
F
3
0
1
2
È
É
Ê
Ì
Î
Í
3 Ë
Ï
Ð
Ñ
Ò
Ó
Ô
Õ
Ö
×
Ø
Ù
Ú
Û
Ô
Ù
Ü
Ý