6-87
•
Unlike other parameter settings, the external fault settings have an input procedure, as shown in the
following diagrams.
1. When setting an external fault function, press the Enter Key when “External Fault” is displayed to
bring up the “Input Level” display.
External Fault
Input level
Detection method
Operation
Selection
2. Press the Increment Key to switch displays as follows:
“Detection Method”
→
“Operation Selection”
→
“Input Method”
3. Press the Enter Key at the desired parameter to select that parameter. At this point, the Increment
and Decrement Keys can be pressed to scroll through the available settings for the selected param-
eter. Press the Enter Key to select the displayed parameter setting.
(Press the Escape Key to cancel the operation without changing the parameter setting.)
Input level
N.O. Contact
N.C. Contact
Set parameter
Detection method
Always
During operation
Operation selection
Ramp to Stop
Coast to Stop
Emergency Stop
Continue operation
Set parameter
Set parameter
Advanced Operation
Chapter 6
Summary of Contents for SYSDRIVE 3G3FV
