7-16
Para
meter
No.
Page
Control mode
Chan-
ges
during
opera-
tion
Default
setting
Setting
range
Description
Name
Para
meter
No.
Page
Flux
vector
Open
loop
vector
V/f
with
PG
V/f
control
Chan-
ges
during
opera-
tion
Default
setting
Setting
range
Description
Display
name
C3-06
Selects out-
put voltage
limit opera-
tion
Selects the output voltage limit
function so that the voltage
calculation in open-loop vector
control does not become
saturated.
0:
Disabled. (Output voltage
saturation is not limited. Slip
compensation is disabled.)
1:
Enabled. (Output voltage
saturation is suppressed.
Speed accuracy is not
reduced.)
0, 1
0
NO
X
X
A
A
6-6
Output V
limit
reduced.)
Note: Be sure that there is suffi-
cient output current ca-
pacity in the inverter be-
cause the output current
is about 10% higher when
this function is enabled.
Note: The speed accuracy may
be reduced when the in-
put voltage is very low.
Note When the control mode is changed, the Inverter reverts to default settings. (The open loop vector
control default settings are given above.)
H
Torque Compensation: C4
Para
meter
Name
Description
Setting
range
Default
setting
Chan-
ges
Control mode
Page
meter
No.
Display
name
range
setting
ges
during
opera-
tion
V/f
control
V/f
with
PG
Open
loop
vector
Flux
vector
C4-01
Torque
compensa-
tion gain.
Sets torque compensation gain
as a ratio.
Note: Usually setting is not nec-
essary.
Adjust in the following cir-
cumstances:
When the cable is long;
increase the set value.
When the motor capacity
is smaller than the capac-
ity of the Inverter (Max.
applicable motor capac-
ity), increase the set val-
ues.
0.00 to
2.50
1.00
OK
B
B
B
X
6-60
Torq Comp
Gain
ues.
When the motor is vibrat-
ing, decrease the set val-
ues.
When adjusting the gain, be
sure that the output current at
low speeds does not exceed
100% of the Inverter’s rated
output current.
Note: Do not change the torque
compensation gain when
using open-loop vector
control.
Parameter Lists
Chapter 7
Summary of Contents for SYSDRIVE 3G3FV
