3-26
Group
Control mode
Comments
Function
Group
Flux
Vector
Open-loop
Vector
V/f
w/PG
V/f
Comments
Function
Terminal
H1
Digital Inputs
Function selection for multi-function inputs
OK
OK
OK
OK
e
a
H2
Digital Outputs
Function selection for multi-function outputs
OK
OK
OK
OK
H3
Analog Inputs
Function selection for analog inputs
OK
OK
OK
OK
H4
Analog Outputs
Function selection for analog outputs
OK
OK
OK
OK
H5
Serial Com Setup
Not Used. (Do not change these settings.)
---
---
---
---
Protection
L1
Motor Overload
Overload protection settings and selection
OK
OK
OK
OK
o ec o
L2
PwrLoss Ridethru
Selects the power-loss processing method.
OK
OK
OK
OK
L3
Stall Prevention
Stall prevention settings and selection
OK
OK
OK
OK
L4
Ref Detection
Frequency detection settings and selection
OK
OK
OK
OK
L5
Fault Restart
Fault restart function settings
OK
OK
OK
OK
L6
Torque Detection
Overtorque detection settings and selection
OK
OK
OK
OK
L7
Torque Limit
Torque limit settings (vector control only)
---
---
OK
OK
L8
Hdwe Protection
Overheating and phase loss protection settings
OK
OK
OK
OK
Operator
o1
Monitor Select
Selects the display and setting methods.
OK
OK
OK
OK
O e a o
o2
Key Selections
Key function selection and other parameters
OK
OK
OK
OK
S
Setting Parameters in Program Mode
The parameters that can be displayed and changed will vary depending on the access level that has
been set.
In the Quick-start level, the first parameter (b1-01) will be displayed when the Enter Key is pressed at the
program mode display. In the Basic level, the first function (b1) will be displayed when the Enter Key is
pressed at the program mode display. In the Advanced level, the first group (b) will be displayed when
the Enter Key is pressed at the program mode display.
For setting examples, refer to
Setting Parameters in Each Access Level on page 3-6.
Preparing for Operation
Chapter 3
Summary of Contents for SYSDRIVE 3G3FV
