6-65
Be sure to set the jump frequency so that d3-03
x
d3-02
x
d3-01.
Internal frequency reference
Set frequency reference
d3-04
d3-03
d3-02
d3-01
H
Hold Reference Memory Selection (d4-01)
Parameter d4-01 selects whether the held frequency during motor operated potentiometer (MOP) sim-
ulation operation is stored when operation is stopped. MOP operation is enabled by making either of the
following settings for the multi-function inputs (H1-01 to H1-06).
Accel/decel ramp hold (set value: A)
UP command (set value: 10)/DOWN command (set value: 11) {MOP increase/decrease}
When hold status is established by these external signals, specify whether or not the output frequency
is to be retained.
When this function is enabled, operation is re-started after power-up using the frequency reference val-
ue that was retained.
Parameter
Display name
Setting
Units
Default
Valid access levels
number
p y
g
range
setting
V/f
Control
V/f with
PG
Open Loop
Vector
Flux
Vector
d4-01
MOP Ref
Memory
0, 1
---
0
Advanced
This parameter cannot be changed during operation.
Explanation of Settings
Setting
Description
0
Disabled. Held frequency during MOP operation is not retained. If a stop command is
given, or if power is removed, the frequency reference is reset to 0Hz. Restart after
operation stoppage or power-up begins at zero.
1
Enabled. Held frequency during MOP operation is retained. If a stop command is given,
or if power is removed, operation resumes at the held frequency reference when the run
command is restored.
For information regarding the accel/decel stop (HOLD) command and the UP and DOWN commands,
refer to
6-5-7 External Terminal Function (H).
Advanced Operation
Chapter 6
Summary of Contents for SYSDRIVE 3G3FV
