Omron SYSDRIVE 3G3FV, User Manual, Page: 135 / 400

5-13
The “Multi-Accel/Decel 1” and “Multi-Accel/Decel 2” inputs will have priority when “Multi-Accel/Decel 1”
and “Multi-Accel/Decel 2” have been set in the multi-function inputs (H1-01 through H1-06).
Parameter Display name Setting
S
Units Default
Valid access levels
number
p y g
range (See
note.)
setting
V/f
Control
V/f with
PG
Open Loop
Vector
Flux
Vector
C1-11 Acc/Dec SW Freq 0.0 to 400.0 Hz 0.0 Advanced
Output
frequency
Acc/Dec Time Switching Frequency
(C1-11)
Acceleration/Deceleration Time 1 (C1-01 and C1-02) are used when the output frequency
≥
C1-11
Acceleration/Deceleration Time 4 (C1-07 and C1-08) are used when the output frequency < C1-11
5-1-6 Disabling Reverse Operation (b1-04)
Parameter b1-04 is used to enable and disable reverse command inputs. This parameter can be set to
“1” to disable reverse operation when necessary. This parameter cannot be changed during operation.
Parameter Display name Setting Units Default
Valid access levels
number
p y g
range setting
V/f
Control
V/f with
PG
Open Loop
Vector
Flux
Vector
b1-04 Reverse Oper 0 or 1 --- 0 Basic or Advanced
Settings
Setting Name Function
0 Reverse Enabled Allows reverse operation.
1 Reverse Disabled Prohibits reverse operation.
5-1-7 Selecting the Stopping Method (b1-03)
Parameter b1-03 sets the stopping method used when a stop command is input. This parameter cannot
be changed during operation.
Parameter Display name Setting Units Default
Valid access levels
number
p y g
range setting
V/f
Control
V/f with
PG
Open Loop
Vector
Flux
Vector
b1-03 Stopping Method 0 to 3 --- 0 Quick-start, Basic, or Advanced
Basic Operation
Chapter 5