NEC NEAX 2000, Programming Manual

Page: 531 / 1200

TIE LINE ACCESS
– 511 –
A2499-10
HARDWARE REQUIRED
LDT card: For Loop Dial Signaling
ODT card: For 2-wire E&M or 4-wire E&M Signaling Trunk
DESCRIPTION DATA
When using the ODT card, specify the 2
wire E&M or 4-wire E&M trunk.
NOTE:
All two circuit must be set as the
same type interface, either 2-
wire or 4-wire in one ODT card.
•
(1)
(2)
Y=105 2-wire E&M/4-wire E&M Trunk
00-63: Trunk Route No.
0 : 2-wire E&M Trunk
1 : 4-wire E&M Trunk
•
(1)
(2)
Y=104 Polarity of E&M Trunk
00-63: Trunk Route No.
1 : E wire (Open), M wire (Open)
2 : E wire (Ground), M wire (Battery)
3 : E wire (Ground), M wire (Ground)
Specify the restriction of incoming call ter-
mination to different Tenant.
•
(1)
(2)
Y=2
XX ZZ
XX: Tenant No. of called station
ZZ: Tenant No. of Trunk
0 : Restricted
1 : Allow
Provide DTMF Receivers for Tie Line In-
coming Calls, if required.
•
(1)
(2)
Y=1
XX ZZ
XX: 00-15: Built-in DTMF Receiver/
PN-8RSTA card No.
Built-in DTMF Receiver: 00
PN-8RSTA: 01-15
ZZ: 0-3: Circuit No.
1 : For both Station and Tie Line
CM63
CM45
END
CM35
D