NEC NEAX 2000, Programming Manual

Page: 1117 / 1200

ND-91285-001(E)
DECEMBER, 1999
Page 335
Revision 1.0
(2/2)
SPLIT CALL FORWARDING - DON’T ANSWER (CONT’D)
OPERATING PROCEDURE (CONT’D)
3. Dial the desired destination number (0-9); receive Service Set Tone.
DESTINATION NUMBER
0 : Target Station for SPLIT CALL FORWARDING - DON’T ANSWER (Block No.0)
1 :
(Block No.1)
2 : (Block No.2)
3 : (Block No.3)
4 : (Block No.4)
5 : (Block No.5)
6 : (Block No.6)
7 : Target Station for SPLIT CALL FORWARDING - DON’T ANSWER (Block No.7)
8 : Target Station for CALL FORWARDING - DON’T ANSWER
9 : SPEED CALLING - STATION
Note: Destination No. 0-7 is pre-assigned in system programming.
4. Replace the handset.
To cancel SPLIT CALL FORWARDING - DON’T ANSWER:
1. Lift the handset; receive Dial Tone.
2. Dial the SPLIT CALL FORWARDING - DON’T ANSWER cancellation code; receive Service
Set Tone.
3. Replace the handset.
SERVICE CONDITIONS
1. This feature allows a station to set the two kinds of call forwarded stations. One is the target station
assigned for CALL FORWARDING - DON’T ANSWER, the other is the target station assigned for
SPLIT CALL FORWARDING - DON’T ANSWER. The target stations for SPLIT CALL FOR-
WARDING is pre-assigned in system programming.
2. Either CALL FORWARDING - DON’T ANSWER or SPLIT CALL FORWARDING - DON’T
ANSWER can be selected for the feature available per tenant in system programming, depending on
the type of the incoming call which is an internal call/attendant assisted call, a Tie Line call, or a C.O.
call.
3. SPLIT CALL FORWARDING - DON’T ANSWER allows any incoming DIRECT INWARD DIAL-
LING (DID), DIRECT-IN TERMINATION (DIT), Tie Line, and internal calls which encounter a no
answer condition to be forwarded to a predetermined location (Attendant Console, another station, or
voice mail equipment).
4. SPLIT CALL FORWARDING - BUSY LINE and SPLIT CALL FORWARDING - DON’T ANSWER
must be set to the same destination to result in SPLIT CALL FORWARDING - BUSY LINE/ - DON’T
ANSWER.