NEC NEAX 2000, Programming Manual

Page: 882 / 1200

ND-91285-001(E)
DECEMBER, 1999
Page 100
Revision 1.0
(1/2)
CALL REDIRECT
GENERAL DESCRIPTION
Without answering incoming calls or held calls which terminates to the line keys of a D
term
, the calls can
be transferred to the station or Voice Mail System (VMS). Two transferring destination number can be
designated per tenant, by system data programming. This feature can be used together with Caller ID Dis-
play feature.
STATION APPLICATION
All D
term
s
OPERATING PROCEDURE
When Caller ID Display feature is provided to the D
term
:
1. Confirm the calling party’s information by the operation of Caller ID Display.
Note:
For the operating procedure of Caller ID Display, refer to the pages of Caller ID Display.
2. While the CID (Caller ID Display) mode (while the CID key lamp lights), press the CRD (Call Re-
direct) key assigned to the programmable key on the D
term
.
The call is transferred to the pre-assigned destination station and the
CID
key lamp goes out.
When Caller ID Display feature is not provided to the D
term
:
1. Press the CRD key. The D
term
comes into CRD (Call Redirect) mode for six seconds, the CRD key
lamp lights.
2. While the CRD mode (while the
CRD
key lamp lights), press the line key of the incoming/held call.
The call is transferred to the pre-assigned destination station and the CID key lamp goes out.
SERVICE CONDITIONS
1. A maximum of 8 D
term
s can operate the CALL REDIRECT simultaneously per system, including the
terminal which is on CID mode.
If the
CRD
key is pressed on the 9th D
term
,
CRD
key lamp lights in a moment (0.5 seconds), then the
call is transferred to the destination station.
2. CRD mode is continued for 6 seconds after the
CRD
key is pressed. After 6 seconds, the
CRD
key
lamp goes out automatically and CRD mode is cancelled.
3. Two transfer destination can be designated per tenant by system data programming. However, one of
these must be a station, and the another must be a voice mail station.
4. If the call cannot be transferred to the destination station due to the busy or restriction of the destina-
tion, CID and CRD mode is cancelled.
5. When the following terminating system is assigned to the trunk, the call which is terminated to the
trunk access key can be transferred by the
CRD
key:
• Trunk line Appearance
• Trunk line Appearance
+
TAS