NEC NEAX 2000, Programming Manual

Page: 1065 / 1200

ND-91285-001(E)
DECEMBER, 1999
Page 283
Revision 1.0
(2/2)
PRIVATE LINES (CONT’D)
SERVICE CONDITIONS (CONT’D)
8. The following are valid methods for making an outgoing call from a PRIVATE LINE:
• Dialing the C.O. trunk access code
• SPEED CALLING-STATION/SYSTEM
• LEAST COST ROUTING
• TRUNK LINE APPEARANCE-D
term
• LAST NUMBER REDIAL
9. PRIVATE LINES are not available when using OUTGOING TRUNK QUEUEING and TIMED
QUEUE.
10. If a station uses a direct trunk line appearance on a D
term
for an outgoing calling, the call is originated
from the C.O. trunk corresponding to the key depressed.
11. Only C.O. (loop start) trunks and Tie Line trunks can be assigned as private lines.
12. If the designated trunk is busy, the system is able to hunt to the next trunk (following increasing trunk
number order). When the route number of the trunk differs from the route number of the original des-
ignated trunk, hunting stops and the caller receives Busy Tone.
13. If a station uses a secondary station on a D
term
for an outgoing calling, the designated trunk for the pri-
mary station of that station is seized.
14. A designated trunk cannot be seized unless the route of the trunk access code is the same as the route
of that trunk.
15. In the case of an outgoing call from an Attendant or a tandem call, a trunk is seized normally, irrespec-
tive of this feature.
16. An ACCOUNT CODE may be entered using a function key programmed for ACCOUNT CODE entry
or ACCOUNT CODE can be dialed on second dial tone.