NEC NEAX 2000, Programming Manual

Page: 874 / 1200

ND-91285-001(E)
DECEMBER, 1999
Page 92
Revision 1.0
(2/2)
CALL PARK - SYSTEM (CONT’D)
OPERATING PROCEDURE (CONT’D)
To retrieve a parked call:
From a Single Line Telephone:
1. Lift the handset; receive Dial Tone.
2. Dial the CALL PARK retrival code; receive Special Dial Tone.
3. Dial PARK No. which parked the call; parked call is then reconnected.
From a D
term
with a TRUNK LINE APPEARANCE:
1. Go off hook and receive Dial Tone.
2. Press
TRUNK LINE APPEARANCE
key flashing.
From an Attendant Console:
1. Press
LOOP
key.
2. Dial the CALL PARK retrieval code (DESK CONSOLE) or press the
CALL PARK - SYS-
TEM
key (SMART CONSOLE).
3. Dial the PARK No. on which the call is parked: Park No. = 00 to 19
4. The parked call is reconnected to the retrieving line.
SERVICE CONDITIONS
1. A maximum of 20 calls can be parked within a system at a time.
2. Any internal or external call can be placed into CALL PARK - SYSTEM.
3. If a parked call remains unanswered for 60 seconds, the station that has activated the CALL PARK is
recalled.
4. The
CALL PARK - SYSTEM
key is available only for the D
term
and Attendant Console.
5. If the trunk which was placed in CALL PARK is assigned to any D
term
as a trunk line appearance, the
system can be programmed on a per system basis whether or not the D
term
can retrieve the parked call
by depressing the Trunk key. Trunk key LED indication is as follows:
a. Possible to retrieve
: flashing Green/Red (hold)
b. Impossible to retrieve : steady Red (busy)