NEC NEAX 2000, Programming Manual

Page: 506 / 1200

STATION MESSAGE DETAIL RECORDING (SMDR)
PROGRAMMING
AP Initialization
– 486 –
A2486-10
AP Initialization
This section explains the data assignment to make the AP active. If the system already applied
the AP related feature, you can skip the data assignment explained on this section. The AP
should have already activated if one of the following feature applied; SMDR (Station Message
Detail Recording), MCI (Message Center Interface), D
term
TIMS (Time Information Management
System), PMS (Property Management System), or Hotel printer. You can distinguish whether the
AP active or not by the RUN lamp indication. The RUN lamp flashes on green color when the AP
is in active.
When you install the AP00 at first time, you should assign the data shown below.
DESCRIPTION DATA
Assign an AP number to the AP00 card.
The AP number must match the SENSE
switch setting on the AP00 card.
•
(1)
(2)
Y=0
04-15, 20-31: AP No.
04: AP00 card
On the AP00 card, set SW1 switch as
shown below.
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
Load the initial data into the AP00 card.
On the AP00 card, set the SW1 switch as
shown below:
(1)
(2) 0000
CCC
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
START
CM05
END
CMD101
INITIAL
SW1
ON
: POSITION TO BE SET
4
3
2
1
AP OFF LINE
SW1
ON
: POSITION TO BE SET
4
3
2
1