NEC NEAX 2000, Programming Manual

Page: 465 / 1200

SPEED CALLING-ONE TOUCH-D
term
– 445 –
A2437-10
(2) To provide the One Touch key to send “Hooking Called Number” to a Centrex, set
the following data in addition to the programming (1).
(3) To provide the One touch key to send “Called DTMF Signal” for such as VMS
operation, set the following data in addition to the programming (1), when the called number
includes a trunk access code. If the called number includes no trunk access code, this data
is not required.
HARDWARE REQUIRED
D
term
with One Touch key and DLC card
DESCRIPTION DATA
Assign the access code for sending of a
Hooking signal to a Centrex.
Maximum of two digits are available.
•
(1)
(2)
Y=0-3
X-XXXX: Access code
A158: Hooking signal to a Centrex
Assign a RECALL key on the D
term
.
RECALL key is used to return to a former
line.
•
(1)
(2)
Y=00
My Line No. +
+ Key No. (90)
F1015: RECALL
Provide the Centrex trunk route with
Centrex function.
•
(1)
(2)
Y=86
00-63: Trunk Route No.
0: Centrex
DESCRIPTION DATA
Specify whether to set consecutive dialing
“*#” as a delimiter between the called num-
ber and the DTMF signal. (1)
(2) 448
0 : *# set as dialed digit
1 : Delimiter between called number
and DTMF signal
CM90
CM35
START
CM20
END
,
START
CM08
END