Hitachi H8S/2670, Reference Manual

Page: 222 / 647

205
Port 2 Register (PORT2)
Bit 7 6 5 4 3 2 1 0
P27 P26 P25 P24 P23 P22 P21 P20
Initial value — * — * — * — * — * — * — * — *
Read/Write R R R R R R R R
Note: * Determined by the state of pins P27 to P20.
PORT2 is an 8-bit read-only register that shows the pin states. PORT2 cannot be written to;
writing of output data for the port 2 pins (P27 to P20) must always be performed on P2DR.
If a port 2 read is performed while P2DDR bits are set to 1, the P2DR values are read. If a port 2
read is performed while P2DDR bits are cleared to 0, the pin states are read.
After a reset and in hardware standby mode, PORT2 contents are determined by the pin states, as
P2DDR and P2DR are initialized. PORT2 retains its prior state in software standby mode.
5.3.3 Pin Functions
Port 2 pins also function as PPG output pins (PO7 to PO0), TPU I/O pins (TIOCA3, TIOCB3,
TIOCC3, TIOCD3, TIOCA4, TIOCB4, TIOCA5, and TIOCB5), interrupt input pins (
IRQ15
to
IRQ8
), and EXDMAC output pins (
EDRAK0
and
EDRAK1
). Port 2 pin functions are shown in
table 5.5.