Fukuda Denshi DynaScope 7000 Series, Operation Manual

Page: 398 / 475

Handling
This section describes precautions for handling the equipment.
C A U T I O N
If you accidentally wet the device, dry it completely and verify it operates safely
before usage.
Handling After Use
y Do not apply excessive force when disconnecting the cables. Always pull on the connector housing
and not on the cable.
y Clean the unit, accessories, and cables, and keep them together in one place for next use.
y Always check for adequate supply of disposable accessories such as ECG electrodes.
If any shortage, contact our service representative to supply as necessary.
Handling the Touch Panel
y The touch panel utilizes exclusive fluorescent light for its backlight.
As this fluorescent light tube has a product life cycle, it needs to be replaced periodically.
If the display becomes dark, flickers, or does not light, contact your nearest service representative.
y
Although the LCD utilizes highly accurate picture elements, occasionally, there may be a few pixels
which do not light or constantly lights. Please note that this is not an equipment failure, and will not
affect monitoring operation.
y Due to its material characteristic, the touch panel expands/contracts depending on the
temperature/humidity. When the touch panel is left unused for a while, or when the ambient
temperature is low, the surface film of the touch panel may expand, but this is not an abnormal
condition. This expansion will be reduced in few hours or half a day after the power is turned ON.
10 － 2