Fukuda Denshi DynaScope 7000 Series, Operation Manual

Page: 138 / 475

Discharging a Patient Erasing Name, Data, etc.
This menu allows clearing the patient name, ID, age, and past measurement data such as tabular
trend, graphic trend, and recall data.
Discharging Procedure
1
Press the Discharge key.
The confirmation display will appear. If the Discharge key is pressed by mistake, press the
Cancel key to return to the previous display.
2
Erase the patient data.
To initialize the patient data and patient information, press the OK key. The data will be initialized
and the screen will return to the home display selected for the display mode. The alarm setup will be
initialized to the selected alarm mode.
Data Description
Patient Data
Erases the following data; trend, table, recall, ST Display, OCRG, cardiac output,
short trend, hemodynamics, P-V / F-V control data, vigilance table, NICO table,
BIS table, ST table, ST trend, respiration table.
The setup condition of recall, table, trend, vigilance table, NICO table, BIS table
will remain.
Patient
Information Erases the following data; patient name, ID, sex, age, height, weight, BSA, blood
type. The patient classification will not be initialized.
Measurement
Condition
Pacemaker use will be set to unused, and impedance respiration measurement
will be set to ON.
The BP zero-balance condition will be cleared.
The NIBP measurement interval will be set to 2.5 minutes.
The NIBP cuff inflation value will be initialized to default value for each patient
classification.
N O T E
z Depending on the ON/OFF setting for “Backup at Discharge” on the Discharge
Mode setup under the Initial Settings, some data may not be initialized.
z If discharge procedure is performed during stopwatch operation, the counting will
stop and the stopwatch time will be reset to “00:00:00”.
5 － 12