Fukuda Denshi DynaScope 7000 Series, Operation Manual

Page: 83 / 475

4 － 35
Cautionary Alarm (Alarm Level 2)
Item Message
ECG
Impedance Respiration
“Check Electrodes”
Option Unit “Option Unit
＊
Disconnect” (
＊
: Option Unit No.)
“ECG Disconnect”
“BP
＊
Disconnect” (
＊
: BP Channel No.)
“SpO
2
Disconnect”
“TEMP
＊
Disconnect” (
＊
: TEMP Channel No.)
Connector Off
“CO Disconnect”
“FAN Error Inoperative”
“FAN Error Short Circuit”
Device
“Board Temp. Error”
Built-in Recorder “Check Rec. Connection”
“Lower aepEX Alarm”
aepEX
“Upper aepEX Alarm”
W A R N I N G
When a parameter is in a connector-off condition, the alarm will be generated
only on the bedside monitor and not on the central monitor. Make sure that the
connector is securely connected. If the waveform/numeric data is not
displayed for a monitored parameter, check the patient’s condition and pay
attention not to miss the connector-off condition.
N O T E
The alarm limit for “Lower aepEX Alarm”, “Upper aepEX Alarm” can be set only on the
aepEX plus and not on the DS-7000.
As the “Lower aepEX Alarm”, “Upper aepEX Alarm” are equipment status alarm,
these will not be stored for recall, alarm recording, “NIBP Measurement at Alarm
Occurrence”, and alarm data list.
N O T E
The “Connector Off” alarm can be cancelled by pressing the (Alarm Silence)
key. Before silencing the alarm, make sure that the disconnected connector is
unnecessary.
Treatment Needed Alarm (Alarm Level 3)
Item Message
Option Unit
“Option Unit ＊ Error” ( ＊ : Option Unit No.)
Notification Alarm (Alarm Level 4)
Item Message
“Waveform Frozen ( ＊ sec.)”
“Touch Key OFF”
“Night Mode”
“All alarms are silenced.”
Operation
“RR/Apnea Alarm Suspended”
“ECG Failed”
ECG
“Artifact”
ECG, Impedance Respiration “Check Electrodes”
Temperature (TEMP1 to 3) “Noise Interference”
“CO
2
Unit Error”
“CO
2
Sensor Failure”
“CO
2
Warm Up”
“CO
2
Cal. Required”
“Check CO
2
Adapter”
“Unknown CO
2
Sensor”
“Out of range”
Capnostat5 CO
2
(HPD-800)
“CO
2
Zeroing”
4
De
scription of
Alarm Messa
ge and Ala
rm
Sound