1
SDE Lighting –
www.sdelighting.com
– Sixty Scan
SDE Lighting Sixty Scan
1.
GETTING STARTED
What’s In The Box?
SDE Lighting Sixty Scan
5ft IEC power cable
User Manual
Congratulations on your purchase of the future of lighting!
Now that you have a Sixty Scan you should carefully unpack the box and
check the contents to ensure that all pieces are present and in good
condition. If anything looks as if it has been damaged in transit, notify the
shipper immediately and keep the packing material for inspection.
Powering Up
All fixtures must be powered directly from a switched circuit and cannot be
run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat
or dimmer channel is used solely for a 0% to 100% switch.
All fixtures must be connected to circuits with a working Ground.
SAFETY PRECAUTIONS
• ALWAYS make sure that you are connecting to the proper voltage.
• This product is intended for indoor use only. To prevent risk of fire or
shock, do not expose fixture to rain or moisture.
• Make sure there are no flammable materials close to the unit while
operating.
• ALWAYS disconnect from the power source before replacing fuse and be
sure to replace with same fuse size and type.
• ALWAYS secure fixture using a safety chain. NEVER carry the fixture by its
cord. Use its carrying handles.
• DO NOT operate at ambient temperatures higher than 113°F (45°C).
• In the event of a serious operating problem, stop using the unit
immediately. NEVER try to repair the unit by yourself.
• NEVER connect the device to a dimmer pack.
• Avoid direct eye exposure to the light source while it is on.
ATTENTION
There are no user serviceable parts in the unit. Do not open
the housing or attempt any repairs yourself. In the event your unit may
require service, please contact SDE Lighting at
Fuse Replacement
With a flat head screwdriver, wedge the fuse holder out of its housing.
Remove the blown fuse from its holder and replace with exact same type
fuse. Insert the fuse holder back in its place and reconnect power.
