Fukuda Denshi DynaScope 7000 Series, Operation Manual

Page: 30 / 475

C A U T I O N
z There are following restrictions when recording the DS-7000 data on the
central monitor recorder or the AU-5500N 8ch Recorder.
y Only manual recording, alarm recording, periodic recording, and recall
recording can be performed on the AU-5500N.
y When a parameter is not measured, the waveform for that parameter
will not be recorded, and measurement data will be recorded as “
− − −
”
or blank.
y The measurement data displayed as “
×××
” will be recorded as “
− − −
”
on the central monitor recorder.
y The QRS symbol, “S” printed on the built-in recorder will be printed as
“N” on the central recorder and AU-5500N.
y For the waveform recording and trend recording, some parameters
may not be able to be recorded depending on the scale.
y When performing table recording or trend recording on the central
recorder, some numeric data may not be recorded depending on the
parameter. Also, there are some trend scales that cannot be recorded.
y If PR is set for the “HR Alarm Source” and BP is set for the “PR
Source”, ECG will not be recorded on the central recorder. PR-IBP
value will be printed instead for the HR value.
y If the measurement unit of BP is kPa, the BP waveform, BP numeric
data, and NIBP numeric data will be treated as not measured data.
y If the measurement unit of temperature is
°
F, the temperature data will
be treated as not measured data.
y If the “RR Alarm Source” selection is other than Impedance ,
respiration waveform will not be output on the central recorder.
y If the “RR Alarm Source” selection is other than GAS , CO
2
waveform
will not be output on the central recorder.
y When trend recording, table recording, or NIBP list recording is output
on the central monitor recorder from the DS-7000, HR value derived
from ECG will be recorded for the HR value and ST trend.
xxviii