Fukuda Denshi DynaScope 7000 Series, Operation Manual

Page: 185 / 475

6 － 37
SpO
2
(Nellcor
®
Model; DS-7000)
This menu allows setting the SpO
2
monitoring condition for DS-7000 (Nellcor
©
Model).
Size
: Sets the pulse wave size
SpO
2
Alarm : Sets ON/OFF the SpO
2
alarm, upper and lower alarm limit, and SEC alarm.
HR/PR Alarm : Sets ON/OFF the HR/PR alarm, upper and lower alarm limit.
C A U T I O N
Take the following precautions when monitoring over a long period of time.
y To avoid skin rash or low-temperature burn, it is recommended to
change the measurement position several times a day.
Be especially careful when continuously using on neonates, infants, or
patients with peripheral circulatory disturbance.
y Direct sunlight to the sensor area can cause measurement error.
Place a black or dark cloth over the sensor in these environments.
When not measuring, unplug the relay cable and sensor from the SpO
2
connector. Otherwise, the outside light may affect the displayed
measurements.
C A U T I O N
z The DS-100A is intended for use on finger for adults weighing over 40 kg
(approximate). Do not use them on children or neonates. Also do not apply
them on the thumb or foot.
z The light-emitting part of the sensor should be over the root of the
fingernail. Do not insert the finger too far into the sensor as it may hurt the
patient.
z The DS-100A is not designed for long-term use. Move the sensor to
another finger every 4 hours or if any inhibition is detected in tissue blood
flow.
z Measuring on a limb with NIBP cuff, arterial catheter, or intracatheter may
result in incorrect measurement.
C A U T I O N
z Do not secure the adhesive tape too tight as it may obstruct the blood flow.
z The pulse wave is normalized for SpO
2
measurement. It does not indicate
perfused blood volume. Check proper probe attachment by observing the
pulse wave.
6
SpO
2