Fukuda Denshi DynaScope 7000 Series, Operation Manual

Page: 406 / 475

C A U T I O N The periodic replacement parts must be replaced at specified period.
C A U T I O N
The IRMA O
2
sensor needs to be replaced every 4 months. Replace within 4
months after opening the package even if it is not used. When the “Replace O
2
sensor” message is displayed, O
2
measurement cannot be performed.
●
To Check the Periodic Replacement Period
The usage duration for each periodic replacement part will be displayed.
Use this information as an indication for the replacement period for each part.
1
Press the Menu
→
Maintenance
→
Parts Usage Time keys.
The usage hours, months, years, or number
of measurements will be displayed for the
respective parts.
2
After replacing the parts, press the Reset key to reset the usage duration.
●
About the Maintenance of MGU-701/MGU-702/Poet IQ
The periodic maintenance of MGU-701/MGU-702/Poet IQ should be performed as follows.
Each Patient : There should be no damage to the accessories and cables and should be
properly connected.
Replace the sampling device and sampling tube.
Every 3 months : Check the accuracy of O
2
sensor using the 80% O
2
mixture calibration gas.
Every 3 months : Clean the housing of the multigas unit if necessary.
Every year : Perform the safety test. Verify the agent gas auto calibration, and calibrate
if necessary. Replace the O
2
cell. Check the gas flow rate and adjust if
necessary. Check the CO
2
absorber, and replace if necessary.
N O T E
If any damage is found on the multigas unit, contact Fukuda Denshi service
representative.
● About the Maintenance of MGU-801P/MGU-802/MGU-803
The periodic maintenance of MGU-801P/MGU-802/MGU-803 should be performed as follows.
Every year : Perform the leakage test and replace the DRYLINE™ Receptacle if
necessary. Check the gas measurement accuracy using the calibration gas.
10 － 10