Ceragon FibeAir IP-20 All-Outdoor Series, User Manual

Page: 277 / 825

User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 277 of 825
Ceragon Proprietary and Confidential
Note: Optionally, you can select from a list of pre-defined service point
options in the
Pre defined options field at the top of the Ethernet
Service Points - Add page. The system automatically populates the
remaining service point parameters according to the system-defined
parameters. However, you can manually change these parameter
values. The pre-defined options are customized to the type of service
to which you are adding the service point.
7 Click Apply , then Close .
6.1.9.4 Editing a Service Point
To edit a service point:
1 Select
Ethernet > Services . The Ethernet Services page opens ( Figure 196 ).
2 Select the relevant service in the Ethernet Services Configuration table.
3 Click
Service Points . The Ethernet Service Points page opens ( Figure 199 ).
4 Select the relevant service point in the Ethernet Services Points – General SP
Attributes table.
5 Click Edit . The Ethernet Service Points – Edit page opens. The Ethernet Service
Points – Edit page is similar to the Ethernet Service Points - Add page ( Figure
202 ). You can edit any parameter that can be configured in the Add Service
Point page, except Service Point ID , Service Point Type , Interface Location ,
and Attached Interface Type .
6 Edit the service point attributes, as described in Table 46 , Table 48 , and
Table 49 .
7 Click Apply , then Close .
6.1.9.5 Deleting a Service Point
You can only delete a service point with an Attached Interface Type of Bundle-C
or Bundle-S if no VLANs are attached to the service point. See Attaching VLANs .
To delete a service point:
1 Select
Ethernet > Services . The Ethernet Services page opens ( Figure 196 ).
2 Select the relevant service in the Ethernet Services Configuration table.
3 Click
Service Points . The Ethernet Service Points page opens ( Figure 199 ).
4 Select the relevant service point in the Ethernet Services Points – General SP
Attributes table.
5 Click Delete . The service point is deleted.
6.1.9.6 Attaching VLANs
When the Attached Interface Type for a service point is set to Bundle-C or
Bundle-S , you can add multiple C-VLANs to the service point.
To add multiple C-VLANs:
1 Select
Ethernet > Services . The Ethernet Services page opens ( Figure 196 ).
2 Select the relevant service in the Ethernet Services Configuration table.