Ceragon FibeAir IP-20 All-Outdoor Series, User Manual

Page: 235 / 825

User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 235 of 825
Ceragon Proprietary and Confidential
Note: The Header Deduplication type column in the Main page and the
Header Deduplication type field in the Edit page are not operational.
To monitor the Header De-Duplication setting and status, use the
Header Deduplication mode and Header Deduplication operational
state columns and fields.
2 For multi-carrier units, select the carrier in the Radio Ethernet and
Compression table (see Figure 169 ) and click Edit . A separate Radio Ethernet
Interface Configuration page opens. The page is essentially identical to the
single-carrier page.
3 Click Edit . The Radio Ethernet Interface Configuration – Edit page opens.
Figure 170: Radio Ethernet Interface Configuration – Edit Page Per Carrier – IP-20C/IP-20C-HP
4 In the Cut through mode field, select Yes to enable Frame Cut-Through or No
to disable Frame Cut-Through.
5 In the Header Compression mode field, select from the following options:
◦
Disabled – Header De-Duplication is disabled.
◦
Layer2 – Header De-Duplication operates on the Ethernet level.
◦
MPLS – Header De-Duplication operates on the Ethernet and MPLS levels.
◦
Layer3 – Header De-Duplication operates on the Ethernet and IP levels.
◦
Layer4 – Header De-Duplication operates on all supported layers up to
Layer 4.
◦
Tunnel – Header De-Duplication operates on Layer 2, Layer 3, and on the
Tunnel layer for packets carrying GTP or GRE frames.
◦
Tunnel-Layer3 – Header De-Duplication operates on Layer 2, Layer 3, and
on the Tunnel and T-3 layers for packets carrying GTP or GRE frames.
◦
Tunnel-Layer4 – Header De-Duplication operates on Layer 2, Layer 3, and
on the Tunnel, T-3, and T-4 layers for packets carrying GTP or GRE frames.
6 Click Apply , then Close
Note: The Utilization threshold field is not applicable.