User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 97 of 825
Ceragon Proprietary and Confidential
2.15
Configuring the Radio Parameters
In order to establish a radio link, you must:
•
Verify that the radio is muted (the
TX Mute Status
should be
On
).
•
Configure the radio frequencies.
Note:
Even if you are using the default frequencies, it is mandatory to
actually configure the frequencies.
•
Configure the TX level.
•
Click
Apply
to apply these configurations.
Note:
If you are using the default values and did not change any other
parameters on the Radio Parameters page, the
Apply
button will be
grayed out. To activate the
Apply
button, change any parameter on
the page, then change it back to the desired value.
•
Set
TX Mute
to
Unmute
.
•
Click
Apply
to apply the unmute.
•
Verify that the radio is unmuted (the
TX Mute Status
should be
Off
).
You can do these tasks, perform other radio configuration tasks, and display the
radio parameters in the Radio Parameters page.
To configure the radio parameters:
1 Select
Radio > Radio Parameters
. The Radio Parameters page opens.
◦
For multi-carrier units, the Radio Parameters page initially displays a table
as shown in
◦
For single-carrier units, a page appears, similar to
an IP-20C/IP-20C-HP page)
.
Figure 37: Radio Parameters Page
–
IP-20C/IP-20C-HP
