User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 676 of 825
Ceragon Proprietary and Confidential
root> platform sync ssm admin radio-interface slot <slot> port
<port> admin off
To enable SSM on an Ethernet interface, enter the following command in root
view:
root> platform sync ssm admin eth-interface slot <slot> port
<port> admin on
To disable SSM on an Ethernet interface, enter the following command in root
view:
root> platform sync ssm admin eth-interface slot <slot> port
<port> admin off
The following command enables SSM on radio interface 2:
root> platform sync ssm admin radio-interface slot 2 port 2
admin on
The following command enables SSM on Ethernet port 1:
root> platform sync ssm admin eth-interface slot 1 port 1 admin
on
20.6
Configuring the Revertive Timer (CLI)
You can configure a revertive timer for the unit. When the revertive timer is
configured, the unit will not switch to another synchronization source unless that
source has been stable for at least the number of seconds defined in the revertive
timer. This helps to prevent a situation in which numerous switchovers occur
when a synchronization source reports a higher quality for a brief time interval,
followed by a degradation of the source's quality. By default, the revertive timer is
set to 0, which means that it is disabled.
To configure the revertive timer, enter the following command in root view:
root> platform sync revertive-timer set rev_time <rev_time>
Table 217: Synchronization Revertive Timer CLI Parameters
Parameter
Input Type
Permitted Values
Description
rev_time
Number
1-1800
The revertive timer, in seconds.
The following command sets the revertive timer as 7 seconds:
root> platform sync revertive-timer set rev_time 7
To display the revertive timer, enter the following command in root view:
root> platform sync revertive-timer show
