Ceragon FibeAir IP-20 All-Outdoor Series, User Manual

Page: 273 / 825

User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 273 of 825
Ceragon Proprietary and Confidential
Table 48: Service Point Ingress Attributes
Parameter Definition
Service point ID This ID is unique within the service. For Point-to-Point and Multipoint
services, the range of values is 1-32. For Management services, the range
of values is 1-30.
Service point name A descriptive name for the service point (optional). The Service Point
Name can be up to 20 characters.
Service point type The service point type. Options are:
•
SAP – Service Access Point.
•
SNP – Service Network Point.
•
MNG – Management service point.
•
PIPE – Pipe service point.
Learning admin Determines whether MAC address learning for incoming frames is enabled
(
Enable ) or disabled ( Disable ). When enabled, the service point learns the
source MAC addresses of incoming frames and adds them to a MAC
address forwarding table.
Allow flooding Determines whether incoming frames with unknown MAC addresses are
forwarded to other service points via flooding. Select
Allow to allow
flooding or Disable to disable flooding.
Allow broadcast Indicates whether frames with a broadcast destination MAC address are
allowed to ingress the service via this service point. Select
Allow to allow
broadcast or Disable to disable broadcast.
CoS Mode Indicates how the service point handles the CoS of frames that pass
through the service point. Options are:
•
sp-def-cos – The service point re-defines the CoS of frames that pass
through the service point, according to the Default CoS (below). This
decision can be overwritten on the service level.
•
Interface-Decision – The service point preserves the CoS decision made
at the interface level. The decision can still be overwritten at the
service level.
•
PCL – Reserved for future use.
•
TCAM – Reserved for future use.
Default CoS The default CoS. If the CoS Mode is sp-def-cos , this is the CoS assigned to
frames that pass through the service point. This decision can be
overwritten at the service level. Possible values are 0 to 7.
Ethernet Service Points – Egress Attributes
Select Egress in the Ethernet Service Points page to display the Ethernet Service
Points – Egress Attributes table. Table 49 ` describes the parameters displayed in
the General SP Attributes table.