User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 285 of 825
Ceragon Proprietary and Confidential
A trigger delay time can be configured, so that when a triggering event takes
place, the ASP mechanism does not propagate the event until this delay time has
elapsed. A trigger delay from 0 to 10,000 ms can be set per LLD ID. The delay time
must be configured via CLI. See
Configuring Automatic State Propagation and Link
It is recommended to configure both ends of the link to the same Automatic State
Propagation configuration.
To configure an Automatic State Propagation interface pair:
1 Select
Ethernet > Interfaces > Automatic State Propagation
. The ASP & LLF
page opens.
Figure 208: ASP & LLF Page
2 Click
Add
. The Automatic State Propagation - Add page opens.
Figure 209: Automatic State Propagation - Add Page
3 In the
Controlled Ethernet interface
field, select an interface that will be
disabled upon failure of the Monitored Radio Interface, defined below.
