User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 723 of 825
Ceragon Proprietary and Confidential
Parameter
Definition
MEG Parameters
MA ID
The MA/MEG ID.
Format
charString in the current release.
Name
The MA/MEG name (43 characters).
Level
The MEG Level (0-7).
Service
The Service ID of the Ethernet service to which the MEG belongs.
CCM Interval
The interval at which CCM messages are sent within the MEG.
Number of MEPs
The number of MEPs that belong to the MEG.
Number of Local MEPs
The number of local MEPs that belong to the MEG.
Number of MIPs
The number of MIPs that belong to the MEG.
SOAM MEP Table Parameters
MEP ID
The MEP ID.
Interface Location
The interface on which the service point associated with the MEP is
located.
MEP Direction
Up or Down.
MEP Active
Indicates whether the MEP is enabled (true) or disabled (false).
MEP CCM TX Enable
Indicates whether the MEP is configured to send CCMs (true or false).
CCM and LTM Priority
The p-bit included in CCMs sent by the MEP (0-7).
MEP MAC Address
The MAC address of the service point associated with the MEP.
MEP Lowest priority fault
alarm
The lowest defect priority that can trigger alarm generation. Defects
with a lower priority will not trigger alarms.
MEP Alarm on time
The amount of time that defects must be present before an alarm is
generated, in msec intervals (250-1000).
MEP Alarm Clear Time
The amount of time that defects must be absent before an alarm is
cleared, msec intervals (250-1000).
Sequence errors CCM
Frames
The number of out-of-sequence CCM messages received.
CCM Messages TX
The number of transmitted CCM messages.
RMEP Parameters
MepId
The MEP ID of the local MEP paired with the remote MEP.
Rmep Id
The remote MEP ID.
operState
The operational state of the remote MEP.
OKorFail Time
The timestamp marked by the remote MEP indicating the most recent
CCM OK or failure it recorded. If none, this field indicates the amount
of time, in msec intervals, since SOAM was activated.
