User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 100 of 825
Ceragon Proprietary and Confidential
iv In the
RSL degradation alarm admin
field, select
Enable
if you want the
unit to generate an alarm in the event that the RSL falls beneath the
threshold defined in the
RSL degradation threshold
field. The range of
values is -99 to 0. By default, the alarm is disabled, with a default
degradation threshold of -68 dBm. The RSL degradation alarm is alarm ID
1610,
Radio Receive Signal Level is below the configured threshold
.
The alarm is cleared when the RSL goes above the configured threshold.
The alarm is masked if the radio interface is disabled, the radio does not
exist, or a communication-failure alarm (Alarm ID #1703) is raised.
v In the
Adaptive TX power admin
field, select
Enable
if you wish the IP-20
to automatically adjust power levels on the fly in order to optimize the
available capacity at every modulation point. See
Note:
The
RSL Connector Source
field is used in dual-carrier systems to
switch between one carrier and the other when measuring RSL at the
BNC connector.
For a description of the read-only parameters in the
Status parameters
section,
Viewing the Radio Status and Settings
2.15.1
Enabling Link ID Mismatch Security
Note
:
This feature is only relevant for IP-20C, IP-20C-HP, and IP-20S units.
You can configure the unit to block all Ethernet traffic over the radio link in the
event of a Link ID mismatch by enabling Link ID Mismatch Security. When Link ID
Mismatch Security is enabled and a Link ID mismatch occurs:
•
All Ethernet traffic over the link is blocked.
•
The operational status of the radio is set to Down.
•
Automatic State Propagation is triggered.
•
You cannot change the Link ID of the remote radio, but the local-remote
channel remains open for other remote configurations.
•
In-band management is lost. Once the mismatch is cleared, in-band
management is automatically restored.
Link ID Mismatch Security must be enabled and disabled via CLI.
To enable Link ID Mismatch Security, enter the following command in root view:
root> platform security link-id mismatch security set admin
enable
To disable Link ID Mismatch Security, enter the following command in root view:
root> platform security link-id mismatch security set admin
disable
To display the current Link ID Mismatch Security setting, enter the following
command in root view:
root> platform security link-id mismatch security show admin
By default, Link ID Mismatch Security is disabled.
