User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 571 of 825
Ceragon Proprietary and Confidential
service[37]>sp add sp-type sap int-type bundle-s-tag spid 10
interface radio slot 2 port 2 outer-vlan 100 sp-name Radio
The following command adds an SAP service point with Service Point ID 10 to
Service 37, with interface type qinq. This service point is located on radio carrier 2
in an IP-20C or IP-20C-HP unit. S-VLAN 100 and C-VLAN 200 are classified to the
service point.
service[37]>sp add sp-type sap int-type qinq spid 10 interface
radio slot 2 port 2 outer-vlan 100 inner-vlan 200 sp-name Radio
The following command adds an SAP service point with Service Point ID 10 to
Service 37, with interface type all-to-one. This service point is located on radio
carrier 1. All traffic entering the system from that port is classified to the service
point.
service[37]>sp add sp-type sap int-type all-to-one spid 10
interface radio slot 2 port 1 sp-name "all-to-one"
The following command adds an SNP service point with Service Point ID 10 to
Service 37, with interface type dot1q. This service point is located on radio carrier
1. VLAN ID 100 is classified to this service point.
service[37]>sp add sp-type snp int-type dot1q spid 10 interface
radio slot 2 port 1 vlan 100 sp-name Radio
The following command adds an SNP service point with Service Point ID 10 to
Service 37, with interface type s-tag. This service point is located on radio carrier
1. S-VLAN 100 is classified to the service point.
service[37]>sp add sp-type snp int-type s-tag spid 10 interface
radio slot 2 port 1 vlan 100 sp-name Radio
The following command adds an SAP service point with Service Point ID 7 to
Service 36, with interface type dot1q. This service point is connected to HSB group
1 (rp1). VLAN ID 100 is classified to the service point.
service[36]>sp add sp-type sap int-type dot1q spid 7 group
rp1 vlan 100 sp-name test1
The following command adds a Pipe service point with Service Point ID 1 to
Service 1, with interface type dot1q. This service point is connected to Eth1.
service[1]>sp add sp-type pipe int-type dot1q spid 1 interface
eth slot 1 port 1 sp-name pipe_dot1q
The following command adds a Pipe service point with Service Point ID 2 to
Service 1, with interface type dot1q. This service point is located on radio carrier
1.
service[1]>sp add sp-type pipe int-type dot1q spid 2 interface
radio slot 2 port 1 sp-name pipe_dot1q_radio
The following commands create a Smart Pipe service between Eth1 and radio
carrier 1. This service carries S-VLANs and untagged frames between the two
interfaces:
