ZyXEL Communications OLT2406, User Manual

Page: 673 / 766

OLT2406 User’s Guide
673
96.4 UNI Port Settings
Use these commands to configure settings on individual UNI ports (ports on the subscriber devices). See
Section 78.5 on page 570 and Section 78.6 on page 571 for UNI port VoIP commands.
96.4.1 UNI Port General Commands
These commands apply to any UNI port.
Table 354 UNI Port General Command Parameters
LABEL DESCRIPTION M P
no remote uniport all
Removes all UNI port configuration. C 13
no remote uniport < aid >
Removes UNI port configuration for the specified
UNI port.
aid
:
uniport-< slot >-< pon >-< ont >-< card >-
< port >
C 13
remote uniport <aid>
Configures UNI port settings.
aid
:
uniport- < slot >- <pon>-<ont>-<card>-
<port>
Please select the corresponding card ID
according to the desired card type.
Card 1: 10_100_1000BASET
Card 2: VEIP
Card 3: POTS
Card 4: VIDEO
Card 5: 10_100BASET
Card 6: 10_100_1000BASET_VEIP
C 13
inactive
Deactivates the specified UNI port. C 13
no inactive
Activates the specified UNI port. C 13
ipbinding vlan <vlan> ip <ip>
Configures a range of IP addresses for the
specified ONT.
Note: Remember to enable static IP
binding using the
remote ont
<aid> ipbinding <cr>
command.
C 13
no ipbinding <cr>
Removes the static IP binding configuration of
the remote ONTs connected to the specified
UNI port. C 13
pmenable <cr>
Enables PM (performance monitoring) to get
counters on the specified UNI port. C 13
pmenable 32-bit
Enables PM (performance monitoring) to get 32-
bit counters on the specified UNI port. C 13
pmenable 64-bit
Enables PM (performance monitoring) to get 64-
bit counters on the specified UNI port. C 13
no pmenable
Disables PM (performance monitoring) to get
counters on the specified UNI port. C 13
port-speed <auto|10-full|100-
full|1000-full|2.5G-full>
Sets the auto detection configuration attribute
in the physical path termination point Ethernet
UNI ME as defined in G984.4. Use auto ora
specific rate and duplex mode. C 13