Chapter 43 Maintenance
OLT2406 User’s Guide
348
The following table describes the labels in this screen.
43.3 Load Factory Default
Follow the steps below to reset the OLT back to the factory defaults.
1
Click the
Click Her
button next to the
Load Factory Default
field.
2
Click
OK
to continue or
Cancel
to abort.
Figure 213
Load Factory Default: Start
If you want to access the OLT web configurator again, you may need to change the IP address of your
computer to be in the same subnet as that of the default OLT IP address (192.168.1.1 or DHCP-assigned
IP).
43.4 Save Configuration
Click
Config 1
to save the current configuration settings permanently to
Configuration 1
on the OLT.
Click
Config 2
to save the current configuration settings permanently to
Configuration 2
on the OLT.
Table 163 Management > Maintenance
LABEL
DESCRIPTION
Current
This field displays which configuration (
Configuration 1
or
Configuration 2
) is currently operating
on the OLT.
Config
This field displays the firmware that was loaded to the OLT.
Firmware
Upgrade
Click
Click Here
to go to the
Firmware Upgrade
screen.
Restore
Configuration
Click
Click Here
to go to the
Restore Configuration
screen.
Backup
Configuration
Click
Click Here
to go to the
Backup Configuration
screen.
Load Factory
Default
Click
Click Here
to reset the current configuration of the OLT. Note that this will not reset the
configuration to the factory default settings.
Save
Configuration
Click
Config 1
to save the current configuration settings to
Configuration 1
on the OLT.
Click
Config 2
to save the current configuration settings to
Configuration 2
on the OLT.
Reboot System
Click
Config 1
to reboot the system and load
Configuration 1
on the OLT.
Click
Config 2
to reboot the system and load
Configuration 2
on the OLT.
Note: Make sure to click the
Save
button in any screen to save your settings to the
current configuration on the OLT.
Summary of Contents for OLT2406
