ZyXEL Communications OLT2406, User Manual

Page: 404 / 766

Chapter 52 Initial Setup
OLT2406 User’s Guide
404
52.8 Looking at the Operating Configuration
Use
show running-config [page]
to look at the current operating configuration. Use
page
to display
one page at a time. For example:
52.9 Configuring Uplink Ports
The management switching card has six uplink ports on the front panel to use for uplink and subtending
connections. Ports 1 and 2 are 1 Gbps. Ports 3 through 6 you can configure as 10 Gbps or 1 Gbps. This
example configures an uplink port on a management switching card installed in slot 1 so the OLT can
use it.
1
Use “msc-1-
<port>
” for an uplink port (use “msc-1-” no matter which slot the active MSC is in). Select an
uplink port on the management switching card (port 1 in this example) and set the speed and duplex.
This example is for a 1 Gb full duplex connection.
OLT2406# show running-config page
Building configuration...
Current configuration:
vlan 1
ip address 192.168.1.1 255.255.255.0
name 1
normal ""
ingress-counter ""
fixed 1-22
forbidden ""
untagged 1-22
exit
vlan 2
ip address 1.0.0.1 255.255.0.0
name 2
normal 17-22
ingress-counter ""
fixed 1-16
forbidden ""
untagged ""
exit
vlan 10
normal 1-3,5-16,18-22
ingress-counter ""
fixed 4,17
forbidden ""
-- more --, next page: Space, continue: c, quit: ESC
OLT2406# config
OLT2406(config)# interface port-channel msc-1-1
OLT2406(config-interface)# speed-duplex 1000-full
OLT2406(config-interface)# exit