ZyXEL Communications OLT2406, User Manual

Page: 605 / 766

Chapter 83 OSPF Commands
OLT2406 User’s Guide
605
This example configures an OSPF interface for the 172.16.1.1/24 network and specifies to use simple
authentication with the key 1234abcd . The priority for the
OLT
is also set to 1 , as this router should
participate in router elections.
In this example, the OLT ( Z ) is a redistributor between a RIP network and an OSPF network. It summarizes
4 routing entries 192.168.8.0/24 ~ 192.168.11.0/24 (learned from RIP router A ) into 192.168.8.0/22 and then
sends it to OSPF router B .
Figure 282 OSPF Redistribution Summary Address Example
This example shows you how to enable the redistribution for RIP protocol and then show all redistribution
entries.
sysname(config)#
interface route-domain 172.16.1.1/24
sysname
(config-if)# ip ospf authentication-key abcd1234
sysname
(config-if)# ip ospf priority 1
sysname# show ip ospf interface
swif2 is up, line protocol is up
Internet Address 172.16.1.1/24, Area 0.0.0.0
Router ID 172.16.1.1, Network Type BROADCAST, Cost: 15
Transmit Delay is 1 sec, State Waiting, Priority 1
No designated router on this network
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:04
Neighbor Count is 0, Adjacent neighbor count is 0
sysname# config
sysname(config)# router ospf 172.16.1.1
sysname(config-ospf)# redistribute rip metric-type 1 metric 123
sysname(config-ospf)# exit
sysname(config)# exit
sysname# show ip ospf database
OSPF Router with ID (172.16.1.1)
(Omit not external part °K)
AS External Link States
Link ID ADV Router Age Seq# CkSum Route
192.168.8.0 192.168.2.2 618 0x80000001 0x02f6 E1 192.168.8.0/24
192.168.9.0 192.168.2.2 618 0x80000001 0xf601 E1 192.168.9.0/24
192.168.10.0 192.168.2.2 618 0x80000001 0xeb0b E1 192.168.10.0/24
192.168.11.0 192.168.2.2 618 0x80000001 0xe015 E1 192.168.11.0/24