ZyXEL Communications OLT2406, User Manual

Page: 356 / 766

Chapter 44 Access Control
OLT2406 User’s Guide
356
44.3.1 Configuring SNMP Trap Group
From the SNMP screen, click Trap Group to view the screen as shown. Use the Trap Group screen to
specify the types of SNMP traps that should be sent to each SNMP manager.
Figure 220 Management > Access Control > SNMP > Trap Group
The following table describes the labels in this screen.
Username Enter the username to be sent to the SNMP manager along with the SNMP v3 trap.
This username must match an existing account on the OLT (configured in Management >
Access Control > Logins screen).
Apply Click Apply to save your changes to the OLT’s run-time memory. The OLT loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 167 Management > Access Control > SNMP (continued)
LABEL DESCRIPTION
Table 168 Management > Access Control > SNMP > Trap Group
LABEL DESCRIPTION
Trap Destination IP Select one of your configured trap destination IP addresses. These are the IP addresses of the
SNMP managers. You must first configure a trap destination IP address in the
SNMP Setting
screen.
Use the rest of the screen to select which traps the OLT sends to that SNMP manager.
Type Select the categories of SNMP traps that the OLT is to send to the SNMP manager.
Options Select the individual SNMP traps that the OLT is to send to the SNMP station. See SNMP Traps
on page 364 for individual trap descriptions.
The traps are grouped by category. Selecting a category automatically selects all of the
category’s traps. Clear the check boxes for individual traps that you do not want the OLT to
send to the SNMP station. Clearing a category’s check box automatically clears all of the
category’s trap check boxes (the OLT only sends traps from selected categories).