ZyXEL Communications OLT2406, User Manual

Page: 608 / 766

Chapter 84 File Management
OLT2406 User’s Guide
608
This is a sample FTP session saving the current configuration to a file called “config.cfg” on your
computer.
ftp> get config config.cfg
This is a sample FTP session updating an ONT image to the OLT.
ftp> put ont.bin ont
If your (T)FTP client does not allow you to have a destination filename different than the source, you will
need to rename them as the OLT only recognizes “config” and “ras”. Be sure you keep unaltered copies
of both files for later use.
Be sure to upload the correct model firmware as uploading the wrong
model firmware may damage your device.
84.2.2 FTP Command Line Procedure
1
Launch the FTP client on your computer.
2
Enter
open
, followed by a space and the IP address of your OLT.
3
Press
[ENTER]
when prompted for a username (the default is “admin”).
4
Enter your password as requested (the default is “1234”).
5
Enter
bin
to set transfer mode to binary.
6
Use
put
to transfer files from the computer to the OLT, for example,
put ras
transfers the firmware on
your computer to the OLT and renames it to “ras”. Similarly,
put config
transfers the configuration file
on your computer (config.cfg) to the OLT and renames it to “config”. Likewise
get config config.cfg
transfers the configuration file on the OLT to your computer and renames it to “config.cfg”. See Table
314 on page 607 for more information on filename conventions.
7
Enter
quit
to exit the ftp prompt.