ZyXEL Communications OLT2406, User Manual

Page: 660 / 766

Chapter 96 Remote ONT
OLT2406 User’s Guide
660
ipbinding <cr>
Enables static IP binding for the remote ONT.
Use the
remote uniport <aid> ipbinding
vlan <vlan> ip <ip>
command to configure
a range of IP addresses for the remote ONTs.
Note: It doesn’t matter if you configure the
IP address range for static IP binding
first. Remember to enable static IP
binding afterwards.
C 13
no ipbinding <cr>
Disable static IP binding for the remote ONT. C 13
loopback-test
Executes a loopback test between the OLT and
an ONT. The console displays whether the
loopback test succeeded or failed. C 13
loopguard <enable|disable>
Enables or disables the loopguard feature on
the remote ONT. C 13
recoveryLoopguard <time>
Specifies after how many seconds the disabled
port(s) will be activated.
<time>: 30-3600
C 13
no recoveryLoopguard <cr>
Resets the recovery time that the disabled
port(s) will be activated to default. C 13
detectedLoopguard <time>
Specifies the time interval (from 1 to 120
seconds) at which the ONT sends loop guard
detection packets. C 13
no detectedLoopguard <cr>
Resets the time interval (from 1 to 120 seconds)
at which the ONT sends loop guard detection
packets to default. C 13
no inactive
Activates on the ONT. C 13
password < password >
Sets the ONT password.
password
: ASCII characters (20 hex numbers).
C 13
plan-version < version >
Sets the ONT planned version to check if the
current ONT setting is synchronized with the MIB
database.
version
: Up to 14 characters.
C 13
plan-version <cr>
Clears the ONT planned version. C 13
sn < sn >
Sets the ONT serial number in 8 hexadecimal
characters (16 characters). C 13
stormThreshold <value>
Sets the maximum rate in packets per second
(pps) that packets are allowed to arrive at the
remote ONT. C 13
no stormThreshold <cr>
Resets the maximum rate in packets per second
(pps) that packets are allowed to arrive at the
remote ONT to default. C 13
wan help
Provides more information about the specified
command. C 13
Table 352 Remote ONT Commands (continued)
COMMAND DESCRIPTION M P