ZyXEL Communications OLT2406, User Manual

Page: 481 / 766

OLT2406 User’s Guide
481
C
HAPTER
64
Bandwidth Control
64.1 Overview
This chapter shows you how you can cap the maximum bandwidth using the bandwidth control
settings.
64.2 Bandwidth Control Commands
Bandwidth control means defining a maximum allowable bandwidth for out-going traffic flows on a
port.
The following table describes the related commands.
Table 241 Bandwidth Control Commands
COMMAND DESCRIPTION M P
bandwidth-control
Enables bandwidth control on the OLT. C 13
no bandwidth-control
Disables bandwidth control on the OLT. C 13
interface port-channel < aid >
Enters the sub-command mode for configuring
the specified ports.
aid
:
<msc|ge|pon>-< slot >-< port >
C 13
bandwidth-limit cir < kbps >
Sets the ports’ Committed Information Rate
(CIR) bandwidth limit in Kbps. C 13
bandwidth-limit cir <cr>
Enables the CIR bandwidth limit on the port. C 13
bandwidth-limit egress
Enables bandwidth limits for outgoing traffic on
the ports. C 13
bandwidth-limit egress < kbps >
Sets the maximum bandwidth allowed for
outgoing traffic on the ports. C 13
bandwidth-limit pir < kbps >
Sets the ports’ Peak Information Rate (PIR)
bandwidth limit in Kbps. C 13
bandwidth-limit pir <cr>
Enables the PIR bandwidth limit on the ports. C 13
bandwidth-threshold egress
< kbps >
Sets the interface’s bandwidth rate threshold for
outgoing traffic.
The range of an XE port is from
0
to
10000000
Kbps.
The range of a GPON port is from
0
to
2500000
Kbps.
The range of a GE port is from
0
to
1000000
Kbps.
C 13