Chapter 40 Static Route
OLT2406 User’s Guide
328
Figure 201
IP Application > Static Routing
The following table describes the related labels you use to create a static route.
Table 149 IP Application > Static Routing
LABEL
DESCRIPTION
Active
This field allows you to activate/deactivate this static route.
Name
Enter a descriptive name (up to 10 printable ASCII characters) for identification purposes.
Destination IP
Address
This parameter specifies the IP network address of the final destination.
IP Subnet Mask
Enter the subnet mask for this destination. Routing is always based on network number. If you
need to specify a route to a single host, use a subnet mask of 255.255.255.255 in the subnet mask
field to force the network number to be identical to the host ID.
Gateway IP
Address
Enter the IP address of the gateway. The gateway is an immediate neighbor of your OLT that will
forward the packet to the destination. The gateway must be a router on the same segment as
your OLT.
Metric
The metric represents the “cost” of transmission for routing purposes. IP routing uses hop count as
the measurement of cost, with a minimum of 1 for directly connected networks. Enter a number
that approximates the cost for this link. The number need not be precise, but it must be between
1 and 15. In practice, 2 or 3 is usually a good number.
Add
Click
Add
to insert a new static route to the OLT’s run-time memory. The OLT loses these changes
if it is turned off or loses power, so use the
Save
link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to reset the above fields to your previous configuration.
Clear Click
Clear
to set the above fields back to the factory defaults.
Index
This field displays the index number of the route. Click a number to edit the static route entry.
Active
This field displays
Yes
when the static route is activated and
NO
when it is deactivated.
Name
This field displays the descriptive name for this route. This is for identification purposes only.
Destination
Address
This field displays the IP network address of the final destination.
Subnet Mask
This field displays the subnet mask for this destination.
Summary of Contents for OLT2406
