Zeiss LSM 880, Operating Manual

Page: 529 / 690

CHAPTER 1 - SYSTEM OPERATION
LSM 880 Center Screen Area / Image Containers - Display and Image Analysis ZEISS
10/2014 V_01 000000-2071-464 523
6.19.6 Model Functionalities
Activate Model under the RICS view. The Model options will be displayed in the View control window
(Fig. 736).
Fig. 736 Fit control window
With the
Model pull down menu you can select a
saved pre-defined model from the list. You can
rename a created or changed model by typing in a
new name in the display box. If the
Ok button is
pressed, the model will be saved under the new
name (Fig. 737). If the model name was not
changed, you will be prompted to acknowledge to
overwrite the old existing one in the
Save Model
Warning
menu (Fig. 738). Press
Yes
to overwrite,
No to keep the old model.
Type in a name in the
Model name display box
and press
Ok
, if you want to save the model, or
press Cancel without saving. You can delete a
model by pressing the
Cross
button. You will be
prompted to acknowledge the action within the
popped up
Delete Model menu (Fig. 739). Press
Yes to delete, No if the model should be kept.
Below the Model pull down box the available
terms to assemble a model are listed. If you want
to take a term into account, check the
corresponding box. Four terms are available:
Scanning G
s
,
Offset d
,
Amplitude A
and
Translation G
d
. The assembled model will be
displayed in the spatial correlation G(
ξ
,
ψ
) display
area.
Fig. 737 Model Save menu
Fig. 738 Save Model Warning menu
Fig. 739 Delete Model menu