Zeiss LSM 880, Operating Manual

Page: 255 / 690

CHAPTER 1 - SYSTEM OPERATION
LSM 880 Left Tool Area and Hardware Control Tools ZEISS
10/2014 V_01 000000-2071-464 249
5.3.13 Action Buttons for FCS
The Action buttons are used to trigger
measurements and to adjust the measurement
conditions. The following buttons are available
(Fig. 333):
−
New: opens up a new Image FCS Diagram
within a container.
−
Count rate:
opens the
Count rate
window.
−
xyz-Scan:
triggers a one dimensional (x, y, z)
or two dimensional (xy, xz, yz) scan.
−
Snap: Starts a single measurement at the first (Sample Carrier) or highlighted (LSM Image) position.
−
Start Experiment: Starts sequential measurements on all marked or highlighted positions.
−
Stop:
Ends or interrupts the current measurement (Appears only when a measurement is actively
running and replaces than the Start Experiment and the Snap buttons simultaneously.
Scans and measurements are performed according to the settings and methods defined in the FCS
tools.
Above and below the
Action buttons the Method tool and Activation tab areas are available.
Besides the action button the Method tool allows to save, load and delete methods. The active tab area
allows some of the tabs to be activated by checking the corresponding boxes.
Fig. 333 Action buttons